Thread production by
helical interpolation within the pitch
JEL® Thread milling cutters
In thread milling, the thread is produced by doing an helical interpolation. The cutting process
enables the production of threads from a nominal diameter of 1 mm (single profile), with
multi-profile from M2. Some tools are also equipped with countersinkers and/or face cutters.
Your PLUS:
- The thread depth is equal to the drill depth if tool is not used for chamfering
- Lower torque than with tapping and roll form tapping
- Short milling chips avoid chip problems
- High Speed Cutting (HSC) possible
Range overview JEL® Thread milling cutters:
JEL® MGF
Ø: 2.0 to 20.0 mm
For defined thread lengths
of 1.5xD, 2xD and 2.5xD
With shank-side chamfer
JEL® MGF XH
Ø: 3.0 to 16.0 mm
For defined thread lengths of
1.5xD with shank-side chamfer.
Thread milling direct into
hardened materials from 45HRC
JEL® MGF XH MICRO
Ø: 1.0 to 2.5 mm
For defined thread lengths of
1.5xD with shank-side
chamfer. Thread milling
direct into hardened materials
from 45HRC
JEL® MGF XS
Ø: 4.0 to 20.0 mm
For defined thread lengths of
1.5xD and 2xD. With shank-side
chamfer. For steel machining beginning from 900 N/mm² tensile strength
JEL® UMGF
Ø: 6.0 to 16.0 mm
For variable thread lengths
up to 2xD and 2.5xD
With face- and shank-side
chamfer
JEL® MKG
Ø: 4.0 to 14.0 mm
Thread milling 2xD
JEL® GWF TOMIL SR / XS
Ø: from 20.0 mm
Thread lengths up to 48 mm
possible. GWF XS for steel
machining beginning from 900 N/mm² tensile strength
JEL® GWF TOMILL GP
Ø: from 20.0 mm
With face-side chamfer and face milling cutter. Thread lengths up
to 45.0 mm possible
JEL® GWF TOMILL CUT
Ø: from 20.0 mm
Coarse picth threads up to M64,
2xD possible
Machining sequence in thread milling
- Enlarged view
